SureClean is a powerful, super-concentrated non-acid multi-use cleaner that dislodges deep-set dirt and grime, tire scuffing, and environmental soiling. SureClean’s unique Clean Rinse Technology allows residue to be quickly and easily rinsed away with a high or low-pressure washer. It is biodegradable and environmentally friendly phosphate-free formula replaces most harsh acid cleaners and its alkaline nature will help neutralize acid-based detergents and cleaners.
- Powerful Cleaner for Routine Maintenance & Restoration
- Removes Embedded Soil & Tire Scuffing
- Prepares Unsealed Surfaces for Sealing
- Super Concentrated Formula
Suitable Surfaces
Ideal for concrete and clay pavers, concrete flatwork, and retaining walls. Can also be used on manufactured and natural stone, tile, terrazzo, and stucco. Works on both horizontal and vertical applications.
SureClean is compatible with all Surebond Sealers with proper dilution, dwell time, and application. Misuse may cause damage to the sealer. A test area is always recommended to determine product suitability and compatibility with your specific surface before use and also if desired results are achievable.
Surface & Air Temperatures
Excessively high or low temperatures will produce poor results. Best cleaning results are obtained when air and surface temperatures are 40° F or above. Do not clean when temperatures are below freezing or will be overnight. If freezing conditions exist, allow adequate time for the surface to thaw. If air temperatures exceed 90° F, flash cool the surface with water before applying the product. Do not allow product to dry on a hot surface.
Preparation
Sweep and remove all loose soil and debris from the surface. Protect adjacent and surrounding surfaces not intended to be cleaned. Inspect the area for visible staining to determine stain types and quantity. If necessary, perform spot cleaning with S.R.B. Stain & Rust Buster and/or Oil Extractor prior to overall cleaning. Before using SureClean, test on a small, inconspicuous area to determine the suitability, dilution, and correct dwell time of this product for your surface. Allow test areas to dry thoroughly before evaluating the final appearance and results.
Dilution
SureClean is a super-concentrated cleaner that needs to be diluted prior to use. The amount of dilution is dependent on the level of strength needed for cleaning. See ‘Coverage Rates’ for the amount of product needed for your surface. To make a dilution that is ready to use, pour the desired amount of SureClean into an empty and clean container, then fill the balance of the container with water and mix. Under dilution (too strong) may cause damage to the substrate. Only use what is needed to efficiently clean.
Application
Apply dilution of SureClean determined from pre-test using a low-pressure sprayer such as a garden sprayer. Allow the cleaner to soak into the surface for 5 to 10 minutes. Improve results by scrubbing the surface with a brush to agitate and break down stains. If desired, brushless cleaning requires the cleaner to be applied on the surface using two applications back to back. Use a hot water high-pressure washer to draw out and further break down surface stains. Rinse the surface thoroughly. It may be necessary to use stronger concentrations and secondary cleanings to remove heavier, deep-set stains. Only use as much pressure as needed to thoroughly clean as excessive-high pressures can damage substrates.
For Full Instructions, Coverage, and Dilution, see the Product Data Sheet.
{youtube}SchndkfsXpE{/youtube}
